Friday 1 March 2013

Sunday, 27 January 2013

20 ~ 26 January 2013 (Week 2)

 Title of Activity

-Doing the exercise for getting started with LABVIEW in order to get the concept from the software chapter by chapter .

Objective: 

-To understand what is LABVIEW and what is the procedure for it .
-Analyse the signal of each part and construct the block diagram for it to get the signal .


 Content/Procedure:

-Acquiring a signal .
-Wile loop .
-Adding a knob to the front panel to control the amplitude .





 

-The front panel controls simulate the input on a physical instruments and supply data to the block diagram of the VI.Many physical instruments have knobs you can turn to change an input value .


-For the block diagram as shown below is showing the simulate signal wired up with wave graph to get the fully signal , by controlling by the knobs you can turn to change the input value and amplitude as well .




-the while loop , the terminal inside the loop are representation of front panel controls and indicators.Terminal are entry and exits ports that exchange information between the front panel and block diagram .


Result & Analysis

-As a result for this week to make sure that we can get the signal of acquiring signal through some of the controls such as knobs to turn the input value and the amplitude as well , and adding while loop to the block diagram .

-As analysis , to get the concept of building a virtual instruments .








No comments:

Post a Comment